ADJ Products, LLC - www.adj.com - Inno Beam LED Instruction Manual Page 13
ADJ Products, LLC - www.adj.com - Inno Beam LED Instruction Manual Page 14
either “Show”, “Blackout”, or “Hold” will be displayed beneath.
2. Press ENTER and the bottom choice will begin to flash. Use
the UP or DOWN buttons to choose an operating mode you
would like the unit to start up in when power is applied or the
DMX signal is lost.
• Show - If the DMX signal is lost, or interrupted, the unit will
automatically go into the last selected show mode.
• Blackout- If the DMX signal is lost or interrupted, the unit will
automatically go into stand by mode.
• Hold - If the DMX signal is lost, or interrupted, the fixture will
stay in the last DMX setting. If power is applied and this mode is
set, the unit will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
Sound State
- In this mode the unit will run in sound
active mode.
1. Press the MENU button until “Sound State” is displayed, press
ENTER.
2. Either “On” or “Off” will now be displayed. Use the UP or
DOWN buttons to toggle between “On” and “Off”.
3. Press ENTER to confirm your selection, the press and hold the
MENU button to activate.
Sound Sense
- In this mode you can adjust the sound
sensitivity of the sound active mode.
1. Press the MENU button until “Sound Sense” is displayed,
press ENTER.
2. Press the UP or DOWN buttons to adjust the sensitivity level.
The sensitivity level can be adjusted between 0 (the lowest) and
100 (most sensitive).
Inno Beam LED
System Menu
2. “Show X” will now be displayed, “X” representing a number
between 1-4. Press the UP or DOWN buttons to find your desired
show and press ENTER to confirm.
3. Press and hold the MENU button for at least 3 seconds to
activate.
Dimmer Mode
- In this mode you can select the dimmer
curve. See page 26 for the different dimmer modes.
1. Press the MENU button until “Dimmer Mode” is displayed,
press ENTER.
2. The current dimmer mode will be displayed.
3. Press the UP or DOWN buttons to find your desired dimmer
mode and press ENTER to confirm.
Slave Mode -
This will let you set unit as a master or
slave in a master/slave configuration.
1. Press the MENU button until “Slave Mode” is displayed,
press ENTER. Either “Slave 1” or “Slave 2” will be displayed.
2. Press the UP or DOWN buttons until your desired slave
mode is displayed, press ENTER to confim.
NOTE: In a Master/Slave configuration you can make one
fixture the Master and then set the next fixture to “Slave 2”, the
fixtures will now have contrast movement to each other.
No DMX
- This mode can be used as a precaution mode,
that in case the DMX signal is lost, interrupted, or power is
lost, the operating mode chosen in the setup is the running
mode the fixture will go into when the DMX signal is lost. You
can also set this as the operating mode you would like the
unit to return to when power is applied.
1. Press the MENU button until “NO DMX” is displayed, and
Inno Beam LED
System Menu