ADJ Products, LLC - www.adj.com - Inno Beam LED Instruction Manual Page 19
ADJ Products, LLC - www.adj.com - Inno Beam LED Instruction Manual Page 20
Operating Modes:
• Sound Active mode -
The fixture will react to sound, chasing through the built-in programs.
• Show mode -
The fixture will run one of four shows that you choose.
• DMX control mode -
This function will allow you to control each individual fixtures traits
with a standard DMX-512 controller such as the Elation
®
Show
Designer.
™
Universal DMX Control:
This function allows you to use a Elation
®
universal DMX-512 controller to control the chases and patterns,
dimmer and strobe. A DMX controller allows you to create unique
programs tailored to your individual needs.
1. The Inno Beam LED has 2 DMX modes; a 12 channel mode and
14 channel mode. See pages 22-27 for detailed description of the
DMX values and traits.
2. To control your fixture in DMX mode, follow the set-up procedures
on pages 8-10 as well as the set-up specifications that are includ-
ed with your DMX controller.
3. Use the controller’s faders to control the various DMX fixture traits.
4. This will allow you to create your own programs.
5. Follow the instructions on page 12 to set the DMX address.
6. For longer cable runs (more than a 100 feet) use a terminator on
the last fixture.
7. For help operating in DMX mode consult the manual included
with your DMX controller.
Sound Active Mode:
This mode allows either single unit or several
units linked together, to run to the beat of the music.
1. Press the MENU button until “
Sound State
” is displayed, and
press ENTER. Press the UP or DOWN buttons so that “
ON
”
is displayed and press ENTER.
2. The sound sensitivity can be adjusted by pressing the MENU
button until “
Sound Sense
” is displayed. Press ENTER and use
the UP and DOWN buttons to adjust the sound sensitivity. “0”
being the least sensitive and “100” being the most.
3. The optional UC3 Controller (not included) may be used to con-
trol different functions including blackout.
Inno Beam LED
Operation
Inno Beam LED
Home Adjustment Menu
then press ENTER to confirm. Press the MENU button for one second
to exit.
Gobo Offset
- Home setting adjustment for the gobo
wheel.
1. Press the ENTER button for at least 3 seconds, then press the UP
or DOWN buttons so that “
Gobo Offset
” is displayed, press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and
then press ENTER to confirm. Press the MENU button for one second
to exit.
Prism Offset
- Home setting adjustment for the prism.
1. Press the ENTER button for at least 3 seconds, then press the UP
or DOWN buttons so that “
Prism Offset
” is displayed, press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and
then press ENTER to confirm. Press the MENU button for one second
to exit.
RPrism Offset
- Home setting adjustment for the rotat-
ing prism.
1. Press the ENTER button for at least 3 seconds, then press the
UP or DOWN buttons so that “
RPrism Offset
” is displayed, press
ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and
then press ENTER to confirm. Press the MENU button for one second
to exit.
Frost Offset
- Home setting adjustment for the frost.
1. Press the ENTER button for at least 3 seconds, then press the UP
or DOWN buttons so that “
Frost Offset
” is displayed, press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and
then press ENTER to confirm. Press the MENU button for one second
to exit.
