©
American DJ
®
- www.americandj.com - Flash Duo VS™ Instruction Manual Page 8
Fixture Cleaning:
Due to fog residue, smoke, and dust cleaning the fixture should
be carried out periodically to optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the
outside casing every 20 days.
2. Use a small brush and normal glass cleaner with a soft cloth
to wipe down the inside casing and clean out the cooling
vents every 30-60 days.
3. Always be sure to dry all parts completely before plugging
the unit back in.
4. Frequent cleaning will extend lamp life and ensure fixture reli-
ability.
Cleaning frequency depends on the environment in which the
fixture operates (I.e. smoke, fog residue, dust, dew). In heavy
use we recommend cleaning on a monthly basis. Periodic
cleaning will ensure longevity, and crisp beam output.
Flash Duo VS™
Cleaning
©
American DJ
®
- www.americandj.com - Flash Duo VS™ Instruction Manual Page 7
Flash Duo VS™
Breaker Reset
This unit is equipped with a safety breaker. This breaker is
designed to close the power circuit in the event of an internal
short, reducing the risk of electric shock and fire. To reset the
breaker, push the breaker button in until you hear it pop back
in to place. If the breaker continues to pop, stop using the unit
and contact customer support the unit may require service.
Caution:
Always replace with the exact same type lamp, unless
otherwise specified by an authorized American DJ® technician.
Replace with anything other than the specified part can dam-
age your unit and will void your manufactures warranty.
Warning:
If after you have replaced the lamp and you continue
to blow them, STOP using the unit. Contact customer support
for further instructions, you may have to return the unit for ser-
vicing. Continuing to use the unit may cause serious damage.
Lamp Replacement:
Caution! Never open the unit when in
use. Always disconnect the main power and allow the fixture
ample time to cool before attempting to replace the lamp. Lamp
replacement has been made simple by incorporating a remove
tray that is retained by a single thumb screws. Again, please
remember to always replace with the exact same type lamp.
1. Be sure to follow the proper procedures when handling
halogen lamps. Never touch the new lamp with your bare fin-
gers.
2. Unscrew the three thumb screws that secure the outer half of
the dome cover to the inner half.
3. Once the thumb screws have been removed, remove the
outer half of the dome assembly to expose the lamps.
4. Remove and replace the lamp with an exact match.
5. Reassemble in reverse order.
Flash Duo VS™
Lamp Replacement
Halogen Lamp Warning!
This fixture is fitted with
halogen lamps which are highly susceptible to dam-
age if improperly handled. Never touch the lamps
with your bare fingers as the oil from your hands will
shorten lamp life. Also, never move the fixture until
the lamps have had ample time to cool. Remember,
lamps are not covered under warranty conditions.
