American DJ
®
- www.americandj.com - Accu Fog 1000 Instruction Manual Page 12
American DJ
®
- www.americandj.com - Accu Fog 1000 Instruction Manual Page 11
Accu Fog 1000
System Menu
ADDRESS MENU -
AOO1 - A511
(Value) - This is where you set the DMX address of
the unit.
TEST MENU -
T-01 - T-XX
(Test) - Tests the functions of each channel.
PLAY MENU -
RUN
- Runs the unit as a “master” in master/slave configuration
or, in a stand alone mode. The unit will run in auto mode.
AUDI
(Audio) - Runs the unit as a “master” in master/slave con-
figuration, or in a stand alone. The unit will run in sound active
mode.
AUTO
- Runs the internal program.
RESE (RESET) MENU -
ALL
- Resets all the motors in the unit.
SCAN
- Resets the motors that control pan/tilt.
TIME MENU -
LIFE
- Displays the fixtures total running time.
HEAT
- Displays the heater running time.
CLMP
- Clears the heater running time.
RPAN (REVERSE PAN) MENU -
ON/OFF
- When “On” is chosen it will reverse the pan.
RTILT (REVERSE TILT) MENU -
ON/OFF
- When “On” is chosen it will reverse the tilt.
MIC MENU -
MIC
- With this function you can make the internal mic more or
less sensitive to sound.
Accu Fog 1000
System Menu
DISPLAY MENU -
VALU
(DMX-512 Value) - Display the DMX-512 value of each
channel.
D ON
- Turns digital display off after 2 minutes.
FLIP
- “Flips” the digital display 180º.
SPEC MENU -
LAAU
- Automatically starts the heater when power is applied.
RDMX
- Lets you adjust the DMX address via external controller.
MODE
- 5Ch/7Ch With this function you can switch between 5
channels and 7 channels. See page 33 for the 5 Channel DMX
traits, and 34-35 for 7 Channel DMX traits.
DLOF
- This lets you switch the heater on via DMX.
DFSE
(Default Settings) - Resets the unit to the default settings.
FEED
- Turns the Pan/Tilt feedback (error correction) on/off
VER
(Version) - Displays the software version
EDIT MENU -
STEP
(S-01 - S-48) - These are the steps slots that you write
your programs into. There are at total of 48 steps. See edit pro-
gram, page 25.
SCXX
(SC01 - SC30) - These are the scenes that are stored in
your program. There are a total of 30 scenes.
REC
- This will auto save your custom program.
RUN
- This will run your custom program.
