SD Video Recorder
26 -
TIP:
Information to be shown on screen. There is a dialog box for inputting the text. Maximum: 4 characters.
There are four alarm sources: A01: Sensor1, A02: Sensor2, A03: Sensor3 and OSPD: Over Speed.
LEVEL:
HIGH / LOW; High means Alarm input voltage higher than 5V, and Low means lower than 3V.
TOGGLE:
It will toggle to the camera you set in full screen automatically when sensor(alarm) is triggered.
There are a total of 5 modes: OFF, CH01, CH02, CH 03, CH04.
OUTPUT:
OFF (ON is not available yet).
BEEP:
ON / OFF.
5.8.2 Post Event Record
The DVR system can implement post-recording in modes of alarm recording and motion detection recording.
That means, the DVR system will keep recording for scheduled time after alarm recording completes.
1)
Press
<MENU>
by remote to enter the DVR system menu;
2)
Choose “ALARM” and press
<MENU>
to go to its sub-menu;
3)
Go to “POST EVENT RECORD” and use <
> or <
> to set the post-recording time(0s, 10s, 20s,
30s, 45s, 60s, 180s available).
4)
Press
<OK>
to save the setting and exit.
5.9 Motion Detection
5.9.1 Set Motion Detection Zone
Press
<MENU>
by remote to enter the DVR system menu, choose “ALARM”, go to “MOTION ZONE” and
press
<MENU>
to set the area: Choose the zone(s) which you want to monitor by using <
> , <
> ,
<
> and <
>.
NOTE: Please press <MENU> by remote to confirm after choosing each zone if you need
select more than one zone.
