DO NOT CLEAN
MEDICI MARBLE
WITH PAINT THINNER, ACETONE, LACQUER THINNER, M.E.K., SCRUBBING BUBBLES
or
other chemicals that attack the structural integrity of Resin Based Stone. Use of these chemicals will destroy the
surface of the stone and void your warranty. Soapy water, ammonia based cleaners & Comet will remove most
dirt and residue from all types of finishes. For stubborn stains you may use a non-abrasive Scotchbrite pad.
“Lightly” scrub the stained area in a circular motion to avoid discoloration. The stone is naturally waterproof and
will
not
absorb
spills
or
soil,
simply
wipe
away
with
a
damp
sponge.
Periodic cleaning with a sponge and warm, soapy water will remove any build up of dust or grime. Periodically
check the grout and silicone for any cracks and repair as needed.
CARE & MAINTENANCE OF YOUR SHOWER SYSTEM
SHOWER SYSTEM TROUBLESHOOTING
Correcting Bowed Wall Panels
Medici Marble
Wall Panels are made to be flexible and may have a slight bow.
This condition is normal and the panels will flatten when properly installed. If the panels have been stored
improperly or have become excessively bowed, follow instructions below. Using a hair dryer or heating pad/
blanket, warm up the backside of the panel in the most bowed area. Once the panel becomes malleable, lay
panel
on
a
flat
surface
and
apply
weight
until
cool
and
flat.
Cracked Tile
As with any tile project, a tile can become damaged. Simply cut out the damaged tile, silicone a
replacement
tile
in
place,
and
grout.
Cracked Wall Panel Seam
If your wall panel developed a crack in a grout line, simply grout over the cracked
seam when it is installed. The grout will correct the problem, you will not be able to tell the crack was ever there.
Scratches & Blemishes
Can be removed by wet-sanding the tile surface. Make sure tile surface and sandpaper
are
wet,
and
sand
tiles
until
scratches
and
blemishes
are
removed.
Door Will Not Stay Closed
Adjust height of door sweep to provide proper tension and seal.
Door Leaking
The shower doors are designed not to leak under normal usage when installed properly, and the
water flow is not pointed directly at the vinyl seals, hinges or opening.
13405 Estelle Street, Corona, California
92879 Phone 800-454-2284 Fax
951-734-1480 Visit us at
americanbathfactory.com
13
GROUT
Your American Bath Factory shower has a non-porous surface, which makes it easy to clean. Decorative lines in the
shower wall panels and Sistine Stone floor accents (e.g. 4x4 Diamond) can be grouted if preferred, but it is not
necessary. Showers with any glass tile accents must be grouted. Grout must contain an ACRYLIC ADDITIVE to ensure
proper bonding to the tiles. We suggest grouting in every union joint of shower components.
These are two recommendations we have for grouting the shower:
1.
Traditional powered grout that is non-sanded and instead of water we recommend mixing with an acrylic additive
to aid in adhesion
2.
You can also use a pre-mixed non-sanded grout this comes ready to apply, no mixing necessary this normally
comes in caulking tubes
(no additive needed)
Do not let the grout dry completely onto the shower before removing and cleaning off the excess grout. If grout is
allowed to dry onto the shower components, it will likely be difficult if not impossible to remove without damaging the
shower's surface.
Note: Grout is not covered by ABF Warranty.