©
American Audio
®
- www.americanaudio.com - UCD-100 Instruction Manual Page 19
activating the Pitch Slider (8):
to activate the
PitCh SLiDEr (8)
, you must turn the
pitch function on. Press the
PitCh buttON (10)
for at least 2 seconds to turn on the pitch function,
when the pitch function is activated the
PitCh LED
(9)
will begin to glow. If the pitch function is not acti-
vated the
PitCh SLiDEr (8)
will not function.
13. PITCH ADJUSTMENTS
this function will increase or decrease the playback speed or "PItCH," of a track. the maximum pitch bend
percentage allowed is +/-16%. the
PitCh SLiDEr (8)
is used to decrease or increase the playback pitch. If
the slider is move up (towards the top of the unit) the pitch will decrease, if the slider is moved down (towards
the bottom of the unit) the pitch will increase.
using the Pitch Slider (8):
to use the
PitCh
SLiDEr (8)
slide the slider up and down. Down will
increase the pitch and up will decrease the pitch.
When the slider is in the center position, there is
zero pitch being applied to a track.
figure 15
BaSiC OPEraTiON
using the Pitch Slider Percentage Selector
(10):
You may choose a pitch
operating range at
any time. to change the operating range be sure the
pitch function is turned on, see figure 17. the pitch
percentage can be changed b/-4%, +/-8%,
+/-16%, and 100%. 4% will allow the least amount
of pitch manipulation and 100% will allow the most
amount of pitch manipulation. to adjust the different
values, press the
PitCh ON/OFF buttON (10)
and
tap on the
% buttON (10)
until your desired value is
reached. the L.E.D. of the
% buttON (10);
glowing
yellow for 4%, glowing green for 8%, or glowing red
for 16%, and all LEDs glowing for 100%.
figure 17
figure 16
