©
American Audio
®
- www.americanaudio.com - UCD-100 Instruction Manual Page 18
BaSiC OPEraTiON
12. CHANGING THE TIME DISPLAY (26)/TIME BAR (27):
the time may be displayed in three different modes; total Remain, Remain, and Elapsed. During normal play-
back, pressing the
tiME buttON (5)
as in figure 14, will change the time display information (26) in the LCD.
the following is a break down of the time settings and their definitions:
1) tOtAL REMAIn (34) - this details the time in the
LCD
as the current CDs’ total remaining
time.
2) REMAIn (34) - this details the time in the
LCD
as the current tracks’ remaining running time.
3) ELAPSED - this details the time in the
LCD
as the current tracks’ elapsed running time.
The unit will indicate the ELaPSED time when neither the TOTaL rEMaiN Or rEMaiN indica-
tors are showing.
Note: When playing a Mp3 disc the TOTaL rEMaiN time of a disc cannot be
shown. Only the rEMaiN time and ELaPSED time of the track.
tIME BAR InDICAtOR - the time bar in the LCD visually details the time defined in the
tiME MEtEr (
26
).
this
bar is also dependent on the selected time function;
rEMaiN (34) or tOtaL rEMaiN (34)
.
this bar will begin
to flash when 15 seconds of a track remain and will begin to rapidly flash when three seconds of a
track remain. the flashing bar is a great visual reminder a track is about to end. the flashing bar will
function regardless of which time mode the unit is in.
figure 14
11. SETTING OUTPUT vOLUME LEvEL
this function lets you set the output volume level.
Press the
traCk kNOb (14)
and press either the
(-) PitCh bEND buttON
or the
(+) PitCh but-
tON (11)
depending on if you want to raise or lower
the volume.
figure 13
