Front Panel Cont.
hot, meaning that when the microphone is in use all channels attenuate -15dB except the MIC. When the
microphone is not being spoken into all channels return to normal. In the OFF position, all signals return to
their original level and the microphone is off.
(11) CUE MIXING CONTROL -
Mixes the signal to be monitored. The monitor signal comes from the Prefader.
This means it will not be affected by the channel faders. You can monitor each channel individually. Connect
your headphones to the HEADPHONES jack (14). Slide the CUE MIXING CONTROL (11) to CUE and select
the desired channels with the CUE switches (7). When you slide the CUE MIXING CONTROL to PGM (PFL
switches without function), you can cue the output signal of the mixer. If the CUE MIXING CONTROL is set
to the center position, you can cue both the channel signal you selected and the output signal. With the CUE
LEVEL control (12), you can adjust the phones volume without changing the output signal.
(12) CUE LEVEL CONTROL -
This knob controls the headphone output volume.
(13) MASTER FADER -
This slider control the master output volume.
(14) HEADPHONES JACKS -
Use this jack to connect the headphones. Headphones from 8 Ohms to
600 Ohms can be used. 16 Ohms is recommended. The headphone input is conveniently located on the
face panel.
(15) MIC 1 JACK -
You can connect microphones with a 1/4 inch (6.3mm) jack or XLR connector.
(16) BNC JACK FOR GOOSENECK LAMP -
This jack is used to connect an American DJ 12V DC
gooseneck lamp.
(17) ASSIGN SWITCH -
Used to select which channel is to be mixed with another.
(18) MIC 1 & 2 VOLUME CONTROL -
Adjust the microphone volume of MIC 1 and MIC 2.
(19) MIC BASS, MID, AND TREBLE CONTROL -
Use these controls to fine-tune the MIC 1 signal. Increase
the LOW’s by turning the MIC BASS CONTROL to the right, increase the MID’s by turning the MIC MID
CONTROL to the right, and increase the HIGH’s by turning the MIC TREBLE CONTROL to the right.
(20) SPLIT CUE -
Control and monitor headphone signal. Slide fader to the left to hear the source music from
channel or channels selected by CUE BUTTONS (7). Slide fader to the right to hear PROGRAM MIX (PGM)
output. The smooth CUE MIXING fader is designed for fast and frequent headphone monitoring.
(21) MASTER BALANCE CONTROL -
Used to adjust how much of the signal is sent to the left and right
MASTER OUT jack (31).
(22) PAN CONTROL -
The balance control for each channel, or how much left and right signal for the specific
channel. There is a PAN CONTROL for each of the 3 channels.
(23) ZONE VOLUME, (24) ZONE BASS/TREBLE -
Use ZONE VOLUME (23) and ZONE BASS & TREBLE
(24) knobs to control the output signal for the ZONE. (i.e. other rooms in a club, another amplifier, a satellite
speaker system, a microphone paging system or the DJ control booth monitors).
©
American DJ Audio
®
- www.americandj.com - Q-2422/SX™ User Instructions page 7
