GENERAL FUNCTIONS AND CONTROLS (Cont.) FRONT & REAR PANEL
©
American Audio
®
- www.AmericanAudio.us - Encore 1000 Instruction Manual Page 14
Figure 6
Figure 5
32
30
31
C. FRONT PANEL (FIGURE 5)
30. TRANSPORT TRAY 1 -
This tray is used to load and unload a compact disc. The tray is opened
and closed by pressing the OPEN/CLOSE BUTTON (1). Never attempt to force the transport tray open
or closed when the power is turned off.
31. HEADPHONE JACK -
This jack is used to connect your headphones to the mixer allowing you to
monitor the cue source. Use headphones only rated at 8 ohms to 32 ohms. Most DJ headphones are
rated at 16 ohm, these are highly recommended. Always be sure the CUE LEVEL VOLUME (27) is set
to minimum before you put the headphones on.
32. TRANSPORT TRAY 2 -
This tray is used to load and unload a compact disc. The tray is opened
and closed by pressing the OPEN/CLOSE BUTTON. Never attempt to force the transport tray open
or closed when the power is turned off.
D. REAR PANEL (FIGURE 6)
33. MICROPHONE -
This combo jack will accept a standard 1/4 plug or XLR 3-pin balanced male
plug. The volume output level for this microphone will be controlled by its own respective MIC KNOB
(29).
Note: We recommend that you use a 500-600ohm microphone for the best sound quality.
34. LINE 1 INPUT JACKS -
DO NOT CONNECT TURNTABLES TO THESE JACKS! CD players, Tape
Decks and other line level instruments may be connected to these jacks. The red colored RCA jack
represents the right channel input and the white represents the left channel input. Input volume will
be controlled by channel one fader. The channel SOURCE SELECTOR SWITCH (17) must be in the
"Line 1" position, to monitor any source connected to these jacks.
40
39
36
35
34
33
37
38
