Vision
II
Pro
TM
Manual
Page 23 of 28
If the printer option is installed, press the (PRINT)
button (4). The operator can generate a printout of
the current aim information.
Press the “NEXT” button (5). The aiming cycle for
that lamp is complete and the aimer displays
instructions to move the aimer to the driver side
lamp.
NOTE:
PRESSING THE “NEXT” BUTTON (5)
ENERGIZES THE LAMP CENTERING LASER
5.5 POSITION AIMER TO LAMP
(DRIVER SIDE)
At this screen the lamp alignment laser is energized
and will continue to beep and the screen will display
the message “LASER ON”. Roll the aimer in front of
the
Driver Side
headlamp, place laser target sticker
on lamp identifying the lamp optical center or
fiduciary mark. Place laser on middle of sticker. Set
the Brake Handle. Select the lamp type to be aimed
LOW/HIGH/VOL/VOR/FOG. After the headlamp type
is selected it will de-energize the laser.
AFTER CENTERING,
REMOVE LASER LOCATOR
STICKER
Aim Lamp
The selected lamp type is displayed across the top of
the aim screen above the aim pattern. The
approximate Candela “CD” (brightness) value and
the measurement of the aim point are displayed at
the bottom of screen, these numbers represent how
far the aim is off at 25’ in front of the vehicle. The
value is either in inches or centimeters depending on
what has been selected in the main menu screen.
Adjust lamp as indicated on the screen, if aim is
correct, the aimer will beep and you will get an **AIM
OK** message on the display.
If the printer option is installed, press the (PRINT)
button (4). The operator can generate a printout of
the current aim information.
Press the “NEXT” button (5) after aim has been
completed and the aimer will display “AIM
COMPLETE” push the “NEXT” button (5) again
returns you to the “MAIN MENU”.
