Vision
II
Pro
TM
Manual
Page 22 of 28
5.3 SET BAY NUMBER
The number displayed in the middle of the screen is
the active bay. To change to a different aiming bay,
press the “PLUS” button, to increase the value or the
“MINUS” button to decrease the value until the
desired aiming bay number is displayed. When the
desired aiming bay number is displayed, press the
“NEXT” button (5). The next screen will display
“Position Aimer” and will energize the center lamp
laser.
NOTE: If only one bay is entered this screen will not
be displayed.
5.4 POSITION AIMER TO LAMP
(PASSENGER SIDE)
At this screen the lamp alignment laser is energized
and will continue to beep and the screen will display
the message “LASER ON”. Roll the aimer in front of
the
Passenger
Side
headlamp, place laser target
sticker on lamp identifying the lamp optical center or
fiduciary mark. Place laser on the middle of sticker.
Set the Brake Handle. Select the lamp type to be
aimed
LOW/HIGH/VOL/VOR/FOG.
After
the
headlamp type is selected it will de-energize the
laser.
REMOVE LASER LOCATOR STICKER
Aim Lamp
The selected lamp type is displayed across the top of
the aim screen above the lamp pattern. The
approximate Candela “CD” (brightness) value and
the measurement of the aim-point are displayed at
the bottom of screen, these numbers represent how
far the aim is off at 25’ in front of the vehicle. The
value is either in inches or centimeters depending on
what has been selected in the main menu screen.
Adjust lamp as indicated on the screen, if aim is
correct, the aimer will beep and you will get an **AIM
OK** message on the display. NOTE: The hash
marks on the Horizontal Line represent 2 inches
between the Lines at 25’. The hash marks on the
Vertical Line represent 4” inches between lines at 25’
feet.
