F
EATURES
◆
24 UTP ports all come with NWay auto-negotiation and operate at 10/100
Mbps for connection to servers and hubs. All ports can auto-negotiate for
full or half-duplex operation.
◆
All ports support auto MDI/MDIX, so there is no need to use cross-over
cables or an up-link port.
◆
Store-and-forward switching scheme capability to support rate adaptation
and ensure data integrity.
◆
Auto-polarity detection for correction of incorrect polarity on the receive
twisted pair at each port.
◆
Data forwarding rate 148,800 pps per port at 100% of wire-speed for
100Mbps speed.
◆
Data forwarding rate 14,880 pps per port at 100% of wire-speed for 10Mbps
speed.
◆
Data filtering rate eliminates all error packets, runts, etc. at 148,800 pps per
port at 100% of wire-speed for 100Mbps speed.
◆
Data filtering rate eliminates all error packets, runts, etc. at 14,880 pps per
port at 100% of wire-speed for 10Mbps speed.
◆
Up to 4K unicast address entities per device, self-learning, and table aging.
◆
256K Byte-on-Chip packet buffer per eight ports.
◆
All 24 UTP ports support IEEE802.3x flow control for full duplex and
backpressure flow control for half duplex.
◆
Optional two-port Fiber module (SC type connector) in the front panel for
length extension. These two ports operate at either 100M full duplex or half
duplex by means of a manual setting. Please see Chapter Two for additional
information about module settings.
10/100 Fast Ethernet Switch User’s Guide
1
1
