Amel Super Maramu 2000, Руководство пользователя

Страница: 82 / 139

87
In the galley, above the portside sink, is the remote control panel of the desalinator. This
panel is composed of many instruments :
- 3 lighted quality indicators,
- one On / Off switch,
- one hour metre,
- one flowmeter in glass, to measure the volume of fresh water delivered,
- one tap delivering fresh water for check,
-
one high pressure manometer (in bars),
-
one high pressure control system (regulating wheel)
Pict. 87 – Desalinator control panel
We give here a few simplified instructions for the desalinator, but refer to the manufacturer’s
one too :
 before using, check the opening of seacocks.
‚ if the desalinator hasn’t work for a few days, rinse it with fresh water using the
stop cock right to the 5 microns filter. Like for every rinsing, stop the desalinator
and open the pressure regulator thoroughly (anticlockwise) for 2 minutes, and
then replace this seacock in the
Marche (seawater) position.
ƒ to start, regulator open, switch on the device, let it work 1 minute without
pressure, and do a 1
st
setting with the needle in the green area. This is to eject
air from the circuit ant to obtain a better pressure stability. Check the pressure
and readjust if needed.
„ producing fresh water depends on seawater temperature and on the cleanness
of the filter.
checking the fresh water quality and sending it in the tank is made using a
quality sensor and integrated circuit automatically. If fresh water produced
contains salt, it will be rejected.
† a too much higher pressure setting lights the red default of the desalinator and
stops the device ; in this case, set the pressure lower and start again.