Amel FR-AML SM, Руководство пользователя

Страница: 105 / 130

User’s guide
3-3
- Sonic Speed sensors,
-
ground plates,
- zinc anodes.
j apply on the propeller’s blades, after cleaning and greasing with silicon of the
rotating parts, an adapted primer, and then the antifouling painting system.
k
let dry following the instructions of the manufacturer’s of the antifouling, before
launch.
Remark : before putting the boat in the sea and removing the lifting system, be sure no
water is entering in the bilges.
3.2 Deck
Warning : the Chantiers AMEL advise that any repairs on the fiberglass hull of the Super
Maramu 2000 should be done by skilled workers, able to maintain and repair that kind of
material.
Using abrasive and / or corrosive products and equipment (harsh detergent, stiff brushes, …)
is forbidden.
Using a high pressure water machine is not advised, unless regarding the following
instructions :
-
the distance between the hull and the pipe must be at least 20 cm (approx. 8 in),
- the stream’s pressure must not exceed 80 bars (approx. 1130 PSI),
- never add any abrasive (sand,..) to the stream,
- don’t use the stream perpendicularly to the hull, but at 45°.
If possible, clean with fresh water (if necessary with soapy water) after each navigation. To
avoid the salt deposits, be insistent on :
-
lower parts of the masts,
- blocks,
- furling systems,
- windlass.
3.3 Wood
On the varnished wood, never use aggressive products (trichlorethlyene, acetone, alcohol,
…). Prefer product for glass, with a little quantity in alcohol, or some vinegary water or soapy
water.
About the teak, apply some Teac oil (rub down before if it had turned green).