7
2-3 Expansion
Cards
MCP61P motherboard series offer one 16-LANE PCI-Express x16 graphics slot of 4Gbyte/sec
data transfer rate at each relative direction which get 3.5 times of bandwidth more than
AGP8X and it’s up to a peak concurrent bandwidth of 8Gbyte/sec at full speed to guarantee
the performance and compatibility of GPU graphics add-in cards. The whole series carry two
32-bit PCI slots guarantee the rich connectivity for the I/O peripheral devices.
Chapter 3
Connectors, Headers & Jumpers Setting
3-1 Connectors
(1) Power Connector (24-pin block): ATXPWR1
ATX Power Supply connector.
This is a new defined 24-pins
connector that usually comes with
ATX case. The ATX Power Supply
allows using soft power on
momentary switch that connect from
the front panel switch to 2-pins
Power On jumper pole on the
motherboard. When the power
switch on the back of the ATX
power supply turned on, the full
power will not come into the system
board until the front panel switch is
momentarily pressed. Press this
switch again will turn off the power to the system board.
** We recommend that you use an ATX 12V Specification 2.0-compliant power supply
unit (PSU) with a minimum of 350W power rating. This type has 24-pin and 4-pin
power plugs.
Pin 1
ROW1 ROW2
24-Pin
ROW1 ROW2
Pin 1
20-Pin
PIN
ROW1 ROW2
1 3.3V
3.3V
2 3.3V
-12V
3 GND
GND
4 5V
Soft Power On
5 GND
GND
6 5V
GND
7 GND
GND
8 Power OK
-5V
9 +5V (for Soft Logic)
+5V
10
+12V
+5V
11 +12V
+5V
12 +3V
GND
PCI-E x16 by 16 lane
32-bit PCI Slot