AMD ATI FireMV 2400, Руководство пользователя, Страница: 48 / 64

There are screen defects.
Make sure your monitor supports the resolution and horizontal (kHz) and vertical
(Hz) refresh rates as required by the graphics card. Check your current
resolution, refresh rate, and color depth settings in the Settings and Monitor tabs
in your Display Properties dialog.
Caution:
Ensure that both the graphics card and monitor support the resolution and
refresh rates you select. Incompatible resolution/refresh rate selection may
result in monitor damage. Refer to your monitor's documentation for
recommended resolutions and refresh rates.
The screen image is off-center or there are odd colors.
Try adjusting the brightness, sharpness, contrast, and color balance controls of
your monitor.
Try adjusting the centering and positioning controls of your monitor to position
the picture on the screen.
Set the monitor's RGB inputs (and sync switches, if this option is available) to 75
Ohms, with the sync set to external.
DFP monitor users: Make sure that the DVI plug of your monitor data cable is
digital-only (DVI-D), not integrated analog/digital (DVI-I). Refer to your monitor's
documentation and contact your supplier or the manufacturer of the DFP
monitor for information on how to obtain a suitable data cable plug.
The operating system warns that the graphics card isn't
properly configured.
Make sure that the display resolution and refresh rate settings you have selected
are supported by the monitor you have connected.
Check the driver installation and make sure that all software is correctly loaded
corresponding to your operating system and applications.
Reinstall the drivers for your graphics card.
Stereo glasses are not working properly.
Make sure your stereo glasses are connected to the graphics card when you start
your computer.
Make sure you select a refresh rate of 120 Hz.
Enable the
Quad Buffer Stereo option.
There are bus address or interrupt conflicts.
Make sure that the I/O and memory addresses reserved for the graphics board
are not used by other hardware devices. The integrated on-board VGA controller
of your ATI FireMV/ATI FirePro card uses the following addresses (hex):
40 Reference
ATI FireMV 2400/ATI FirePro 2450
©
2008 Advanced Micro Devices, Inc.