7
is imperative to make sure to mount the cameras properly and position them as efficiently as you can to the areas you
wish to monitor. All positioning actions to the camera will have to be performed manually.
To install the camera onto a wall, follow the steps below:
1.
Use a Torx/Hex wrench (included) to open the dome enclosure by unfastening the three inner hex screws on
enclosure.
2.
Place the installation sticker on the wall or ceiling surface that you wish to mount your camera.
3.
Using the X’s on the installation
sticker, drill 3 holes to allow for the insertion of the included expansion bolts.
4.
If the camera’s cable will be exiting through the wall or ceiling surface, please be sure to
drill an exit hole and pull the
cable through.
5.
If the camera’s ca
ble will be exiting through the side of the camera, route the cable through the U-shaped channel on
the side of the enclosure.
6.
Align the camera with the installation sticker, then line up the 3 screw holes in the camera pedestal to the three
plastic expansion bolts on the installation surface. Put the three included screws through the camera then insert them
into the expansion bolts firmly.
7.
Adjust the camera in the position that you want it to be in, then reattach the dome body to the base of the camera.
Note: Range of lens: vertical (0
°～
+65
°
), horizontal (0
°～
+355
°
). When adjusting the camera into position, please
ensure that the camera’s enclosure does not block the image
or cause reflection of
IR light.
3.3 MicroSD Card Installation Guide
To Install a microSD card into your camera, please refer to the step by step guide below:
Note:
You will need to access the camera’s motherboard to insert the micr
oSD card.
1.
Remove the lens cover for the camera with the supplied wrench tool to access the motherboard.
2.
Locate the provided microSD card slot on the motherboard and slide the clasp back to open.
3.
Place the microSD card, into the provided microSD card slot gold pins down and close the clasp.
4.
Slide the clasp forward to secure the microSD card to the pins and secure the clasp.
