S
ET
THE
IP A
DDRESS
AND
P
ROTOCOL
RBE2-8 User Manual
ADVANCED MICRO CONTROLS INC.
26
2.2b Use the Embedded Web Server
PREREQUISITE:
You must know the present IP address of the RBE2-8. The factory default address is
192.168.0.50.
PREREQUISITE:
Task 1.4:
, found on page 23. You must be able to power the RBE2-8.
PREREQUISITE:
Task 1.5
, found on page 24. You must attach your RBE2-8 to your
computer.
PREREQUISITE:
The network interfaces on your computer must be on the same subnet before you can
communicate with an RBE2-8. Refer to
Configuring Network Interfaces
, which starts on page 17 if needed.
2.2b.1 Disconnect the RBE2-8 from the host controller and cycle power to the RBE2-8.
This ensures that the unit does not have any open connections to the host controller.
2.2b.2 Start your web browser and connect to the RBE2-8
The internal HTML pages should work with any browser. Once your web browser is running, enter the pres-
ent IP address of the RBE2-8 into the address bar. The default address is 192.168.0.50. The unit will respond
with the following page. Note that the Firmware Version number may be different.
Figure T2.1 RBE2-8 Information Webpage
Содержание RBE2-8
Страница 14: ...RBE2 8 INTRODUCTION RBE2 8 User Manual ADVANCED MICRO CONTROLS INC 14 Notes ...
Страница 30: ...PROTOCOL SPECIFIC INFORMATION RBE2 8 User Manual ADVANCED MICRO CONTROLS INC 30 Notes ...
Страница 48: ...MODBUS TCP CONFIGURATION RBE2 8 User Manual ADVANCED MICRO CONTROLS INC 48 Notes ...
Страница 54: ...LEADERS IN ADVANCED CONTROL PRODUCTS ADVANCED MICRO CONTROLS INC ...