AMBROGIO 7060DE0, Руководство пользователя

Страница: 27 / 34

26
User’s manual
EN
Problem Cause Remedy
The flashing of the LEDs
signals a “wheel motor
error” LED flashes.
(1 FLASH of the green ON/
OFF led - Right motor error).
(2 FLASHES of the green
ON/OFF led - Left motor
error)
Uneven ground or ground with
obstacles that impede movement.
Check that the lawn to mow is even and does
not have any holes, stones or other obstacles.
If so, fill in any holes and remove any obstacles
(see “Preparation and defining the boundaries of
the work areas”).
One or both wheel motors has a fault.
Have the motor repaired or replaced by the
nearest authorised service centre.
PLAY
ON
PAUSE
STOP
H
IG
H
B
A
TT
E
R
Y
LO
W
B
A
TT
E
R
Y
OFF
The flashing of the LEDs
signals a “motor/blade
error”.
(3 consecutive FLASHES of
the green ON/OFF led).
Cutting blade damaged.
Replace the blade with a new one (see “Blade
Replacement”).
Cutting blade fouled (tape, ropes,
plastic fragments, etc.).
Stop the robot safely (see “Robot Safety Stop”).
Warning – Caution
Use protective gloves to avoid the risk of
injury.
Remove the cause of fouling of the blade.
The robot was started too close to
obstacles (less than 1 m. (40.00 ")
away) or in the presence of unexpected
obstacles (fallen branches, forgotten
objects, etc.).
Stop the robot safely (see “Robot safety stop”).
PLAY
ON
PAUSE
STOP
H
IG
H
B
A
TT
E
R
Y
LO
W
B
A
TT
E
R
Y
OFF
Remove the obstacles and restart the robot.
Electric motor failure.
Have the motor repaired or replaced by the
nearest authorised service centre.
Too high grass.
Increase the cutting height (see “Cutting height
adjustment”).
Carry out a preliminary cutting of the area with a
normal lawnmower.
The flashing of the LEDs
signals a “tip-over error”.
(4 consecutive FLASHES of
the green ON/OFF led).
Ground with too much slope or with
undefined borders.
Check the installation rules.
(see “Preparation and defining the boundaries of
the work areas”).
Tip-over sensor failure.
Try to restart the robot. If the problem persists,
have the robot repaired by the nearest
authorised service centre.
PLAY
ON
PAUSE
STOP
H
IG
H
B
A
TT
E
R
Y
LO
W
B
A
TT
E
R
Y
OFF
The flashing of the LEDs
signals a “curb drop-off
sensor error”.
(Led (ON/OFF) 5
consecutive flashes).
When the robot is started it does not
detect the curb drop-off sensor data
correctly.
Clean the sensors and start the robot again. If
the problem continues, decide whether to start
the robot with the curb drop-off sensors off,
otherwise contact the Authorised Service Centre
closest to you.
PLAY
ON
PAUSE
STOP
H
IG
H
B
A
TT
E
R
Y
LO
W
B
A
TT
E
R
Y
OFF
The power supply unit does
not turn on.
No electricity.
Check that the power supply unit is correctly
connected to the power outlet.