Doc No. 700015 Page 17 of 36
2
COLOUR CODE
VSX2M
20/25/30
VSX3M
30/35/40/
45
VSX4M
45/50
COLOUR CODE
VSX2M
20/25/30
VSX3M
30/35/40/
45
VSX4M
45/50
M4
Full Nut
1x
2x
M6
Washer
M6
Full Nut
M6 x 35
Setpin
M4
Washer
M6 x 15
Setpin
6x
10x
6x
4x
6x
4x
7x
2x
8x
4x
8x
14x
8x
3x
9x
6x
2.4 Prior to assembly
•
Ensure the area in which you are working is safe and clear of obstructions.
•
Identify with the components in the check list and in which order they will be assembled.
•
Arrange the trestles* in a straight line to allow for length of tubes.
•
Remove all protective plastic from underside of Stainless Steel Reflectors / inside of End Caps.
* if saw horses cannot be located, ensure any alternative is sound and can carry the heater weight.
Methodology: To cater for the expansion of the firing leg, all U bolts on the firing leg (except the one
closest to U bend) are to be loose as described below. All reflectors, tubes, brackets and canopies
are bolted together.
Locate and position tubes on trestles. After
deciding which end will have the burner, mark out the
position of the first bracket as shown in the assembly
drawings section. Slide brackets over tubes as
shown.
1
2.5 Step by step installation.
2.5.1 Tubes and Turbulators
2x 2x 2x
0x 0x 2x
VSX50 only:
Locate & position the two shorter
tubes and affix to tubes using couplers. Keeping
the tubes in line, tighten the couplers evenly until
the tubes cannot be turned in the couplers.
0x 0x 2x
