3.2 Sensor Operation Verification
Verify the indoor and outdoor temperature match closely
with the console and sensor array in the same location
(about 5 to 10' apart). The sensors should be within 2°F
(the accuracy is ± 1°F). Allow about 30 minutes for both
sensors to stabilize. The temperature can be adjusted or
calibrated later to match each other or a known source.
4. Display Features
4.1 Rate of Change Icon
The rate of change icon detects rapid changes in
remote temperature. If the arrow points upward, the
temperature is increasing at a rate of +2°F per 30 minutes
(or greater), If the arrow points downward, the
temperature is decreasing at a rate of -2°F per 30 minutes
(or less).
4.2 Console Operation
Note:
The console has three buttons for easy
operation:
SET
button,
MIN/MAX
button, and
CH/+
button.
4.2.1 Set Mode
The Set Mode allows you to set the time and time format,
time alarm and units of measure.
To enter the set mode, press and hold the
SET
key for
3 seconds.
Version 1.0
©Copyright 2013, Ambient LLC. All Rights Reserved.
Page 8
