5. Insert two AAA batteries.
6. After inserting the batteries, the remote sensor LED indicator will light for
4 seconds, and then flash once per 60 seconds thereafter. Each time it flashes,
the sensor is transmitting data.
7. Verify the correct channel number (CH) and temperature units of measure
(°F vs. °C) are on the display, as shown in
Figure 3
.
Figure 3
(1) temperature
(2) temperature units (°F vs. °C)
(3) channel number
(4) relative humidity
8. Close the battery door. Make sure the gasket (around the battery
compartment) is properly seated in its trace prior to closing the door. Tighten
the set screw.
2.4 Display Console Set Up
1. Move the remote thermo-hygrometer(s) about 5 to 10' away from the
display console (if the sensor is too close, it may not be received by the display
console). If you have more than one thermo-hygrometer, make sure they are all
powered up and transmitting on different channels.
2. Remove the battery door on the back of the display, as shown in
Figure
4
. Insert four AAA (alkaline or lithium, avoid rechargeable) batteries in the back
of the display console
Version 1.0
©Copyright 2013, Ambient LLC. All Rights Reserved.
Page 4
1
2
3
4
