Ambient Weather RC-8401, Руководство пользователя

Страница: 19 / 21

Version 1.1 ©Copyright 2016, Ambient LLC. All Rights Reserved. Page 19
Problem Solution
The wireless sensor communication has
been lost or is intermittent or will not sync
up.

Make sure the transmitter is powered up and the
LED is flashing about once per minute. For cold
weather environments, install lithium batteries.
If the transmitter is not flashing, replace the
batteries.

Resync the console. Reference Section 5.15.

The maximum line of sight communication
range is 150’. Move the sensor closer to the
clock.

If the sensor assembly is too close (less than
5-10’), move the sensor away from the clock.

Make sure the remote sensors are not
transmitting through solid metal (acts as an RF
shield), or earth barrier (down a hill).

Move the clock away from electrical noise
generating devices, such as computers, TVs and
other wireless transmitters or receivers.

Move the remote sensor to a higher location.
Move the remote sensor to a closer location.

Radio Frequency (RF) Sensors cannot transmit
through metal barriers (example, aluminum
siding) or multiple, thick walls.
The clock does not respond to commands.

Press the reset button on the back of the clock
with an open ended paper clip or sharp tool.
The projection is fuzzy

Adjust the focus setting.
The clock is dim when running on
batteries only.

Press the snooze/light button or connect to AC
Power.
The display is green when it should be a
different color

The clock display color will always display
green while the clock is searching for the radio
controlled signal. The mono color green is best
for avoiding interference from the display.
8. Accessories
Accessory Description
TX-8300 Additional wireless sensor.
9. Liability Disclaimer
Please help in the preservation of the environment and return used batteries to an authorized depot.
The electrical and electronic wastes contain hazardous substances. Disposal of electronic waste in
wild country and/or in unauthorized grounds strongly damages the environment.
Reading the “User manual” is highly recommended. The manufacturer and supplier cannot accept any