50D0112
RCSTEBA Installation & Operating Manual
Rel 1.0 April 2009
Page 10 of 10
Ambient Technologies
A Division Of
Monessen Hearth Systems
to the OFF position. Make sure the receiver privacy (DIP) switches are set the same. Follow the
instructions on how to set the privacy (DIP) switch setting.
7.
By disabling this feature, your appliance may continue to run unattended.
Optional Wall Cover Plate:
1. Receiver snaps into wall cover plate. The wall plate is mounted by using 2 screws provided.
TESTING YOUR NEW REMOTE CONTROL SYSTEM
1.
Light your gas appliance following the appliance lighting instructions that came with the appliance.
Confirm that the pilot light is on; it must be in operation for the remote control to operate the main gas
valve and blower. Appliance control knob must be in the ON position, and appliance ON/OFF switch must
be in OFF position.
2.
Slide the 3 position button on the remote receiver to the ON position and the main gas flame should ignite.
3.
Slide the button to OFF and the main gas flame should extinguish, but the pilot light will remain on.
4.
Slide the button to RS (the center position), then press the ON button on transmitter to turn the system ON.
The main gas flame should ignite and blower should come on after the On Delay Time is reached and fan
speed you desire is selected.
5.
Press the OFF button on transmitter to turn the system to OFF. The flame should extinguish (the pilot light
will remain on) and blower should be off after the Off Delay Time you set.
TROUBLESHOOTING
Symptom Causes
Action
1. Battery icon on
LCD on transmitter.
2. LCD display is
blank
3. LCD display shows
“funny” display
1. Low Battery
1. Replace batteries. Change
batteries every 6 months.
2. Check battery installation or
replace batteries.
3. Press Reset button at the back of
the transmitter.
4. Appliance does not
come on.
1. Wiring / Electrical Connections
1. Slide the switch to ON, if
appliance comes ON, wiring is
not the cause.
2. If appliance does not come on,
check wiring connections.
2. Privacy (DIP) switch setting on transmitter
does not match receiver
1. Make sure the transmitter and
receiver have the same DIP
switch settings.
3. Transmitter measures temperature exceeding
99 degrees Fahrenheit and shows “HI” on LCD
1. Move transmitter to a cooler
place and wait until temperature
drops below 99 degree.
4. Distance between the transmitter and receiver
is more than 30 feet
1. Make sure the operating distance
is less than 30 feet
5. Receiver cannot
receive signal.
1. Receiver is installed in an enclosure
1. Make sure the receiver is not
located inside to tight of an
enclosure.
6. Blower is not on
after the fireplace is
turned on
1.
Blower setting is off
2. Blower delay setting is set too high
1. Press FAN key to select Fan
speed you desire.
2. Press and hold FAN key to set
