Amazone Tyrok 400, Оригинальное руководство по эксплуатации

Страница: 64 / 108

6.3.5 Preparing the disc coulter for operation
6.3.5.1 Adjusting the working depth of the disc coulter
REQUIREMENTS
The implement is in working position
IMPORTANT
Risk of damage to the hub due to
excessive working depth
Do not allow the hub of the disc coulter to
sink into the soil.
1. Loosen the bolt
1
until the teeth
2
are
released. At the same time, hold the disc coulter
by the bearing journal
3
.
2. Swivel the disc coulter up or down.
3. Retighten the bolted connection.
4. Check that the teeth are properly seated.
5. Adjust both disc coulters at the same working
depth.
1
2
3
CMS-I-00004928
6.3.5.2 Adjusting the lateral distance of the disc coulter
The disc coulter runs parallel to the plough body
landside.
The lateral distance from the disc coulter to the
plough body landside is 1 to 3 cm.
CMS-I-00003712
CMS-T-00006529-D.1
CMS-T-00007005-B.1
CMS-T-00007006-D.1
6 | Preparing the machine
Preparing the implement for operation
MG7196-EN-GB | G.1 | 26.07.2022 | © AMAZONE 58