General safety instructions
GH HH Super SMARTCUT BAF0009.3 05.17
13
2.7
Safety measures in normal operation
Only operate the machine if all the safety and protection equipment is
fully functional.
Check the machine at least once a day for visible damage and check
the function of the safety and protection equipment.
2.8
Dangers from residual energy
Note that there may be residual mechanical, hydraulic, pneumatic and
electrical/electronic energy at the machine.
Use appropriate measures to inform the operating personnel. You can
find detailed information in the relevant sections of this operating
manual.
2.9
Maintenance and repair work, fault elimination
Carry out prescribed setting, maintenance and inspection work in a
timely manner.
Secure all media such as compressed air and the hydraulic system
against unintentional start-up.
Carefully fix and secure larger subassemblies to lifting gear when
carrying out replacement work.
Regularly check that bolted connections are firmly secured and tight-
en if necessary.
When the maintenance work is completed, check the function of the
safety devices
2.10
Constructive changes
You may not make changes, expansions or conversions to the ma-
chine without the authorisation of AMAZONE. This is also valid when
welding support parts.
Any expansion or modification work shall require the written approval
of AMAZONE. Only use the modification and accessory parts re-
leased by AMAZONE so that the operating permit, for example, re-
mains valid in accordance with national and international regulations.
Vehicles with an official type approval or with equipment connected to
a vehicle with a valid type approval or approval for road transport
according to the German road traffic regulations must be in the state
specified by the approval.
