Coupling and uncoupling the machine
66
Centaur BAG 0070.1 12.08
WARNING
Risk of contusions, cutting, catching, drawing in and knocks
when the machine unexpectedly releases from the tractor!
Use the intended equipment to connect the tractor and the
machine in the proper way.
When coupling the machine to the tractor's three-point hydraulic
system, ensure that the attachment categories of the tractor and
the machine are the same.
Only use the upper and lower link pins provided for coupling the
machine.
Visually check the upper and lower link pins for obvious defects
whenever the machine is coupled. Replace upper and lower link
pins if there are clear signs of wear.
Use a lynch pin on each of the upper and lower link pins in the
pivot points on the three-point frame attachment to secure them
against unintentional release.
WARNING
Risk of energy supply failure between the tractor and the
machine through damaged power lines!
During coupling, check the course of the power lines. The power lines
must give slightly without tension, bending or rubbing on all
movements of the connected machine.
may not scour other parts.
1. Using the lower link pins, secure the ball sleeves to the hinging
points of the three-point attachment frame.
2. Secure each of the lower link pins with lynch pins to ensure that
they do not accidentally become loose.
3. Direct people away from the danger area between the tractor
and machine before you approach the machine with the tractor.
4. Connect the supply lines before coupling machine and tractor.
4.1 Drive tractor up to the machine in such a way that there
remains a gap (approx. 25 cm) between tractor and
machine.
4.2 Secure the tractor against unintentional starting and
unintentional rolling away.
4.3 Check that the tractor's PTO is switched off.
4.4 Connect the supply lines to the tractor.
4.5 Position the lower link hooks so that they are aligned with
the lower linking points on the machine.
5. Now reverse the tractor further towards the machine so that the
tractor's lower link hooks automatically pick up the ball linings on
the machine's lower pivot points.
The lower link hooks lock automatically.
6. Raise the stand into the transport position.
7. Before moving off:
Visually check that the lower link hooks are correctly
locked.
Remove the wheel chocks.
