![background image](http://html1.mh-extra.com/html/amano/pioneer-eclipse-250ap115/pioneer-eclipse-250ap115_operators-manual_2918108007.webp)
7
EN
Appliance Preparation
5. Remove the two packaged bulbs from inside
the HEPA filter.
6. Remove bulbs from packaging and screw into
sockets (Figure 3) attached to the cover.
CAUTION:
Do not use a tool to tighten the bulbs.
Only tighten by hand. Tighten bulbs by grasping the
plastic base. Do not grasp the glass tubes.
7. Carefully reposition the cover (Figure 4) over the
HEPA filter. Make sure cover is oriented as
previously installed and bulbs are not contacting
any surface.
8. Secure cover with retaining screw. Connect
interconnect cord. Device is now ready for
operation.
Operation
1. Unwrap the power cord and plug into the properly
grounded outlet.
2. Make sure the interconnect cord is connected to the
receptacle on the base unit and the receptacle on
the cover above the fan.
3. Place the air mover in the desired operating position.
4. Set the switch at the desired speed: low or high.
Circuit Protection
The 250AP features a circuit breaker that will “trip” if
more than the rated electrical current is drawn through
the cord. In addition, some models are equipped with
a duplex GFCI outlet. The GFCI protection promotes
operator safety and will “trip” if an electrical ground fault
is sensed. To test the GFCI protection, press the TEST
button. If operating properly, the RESET button on the
GFCI outlet will pop out.
Figure 3
Figure 4
Содержание Pioneer Eclipse 250AP115
Страница 1: ...Commercial Air Purifier PE250AP Operator s Manual ...
Страница 51: ...51 Wiring Diagram ...
Страница 54: ...54 Lower Assembly 1 2 2 3 3 3 3 4 5 6 7 8 9 10 11 12 16 20 21 22 23 24 25 27 26 17 18 19 15 ...
Страница 63: ...63 ...