Amano MJ Series, Руководство по эксплуатации

Страница: 35 / 40

－３１－
Periodic Inspection Table
For your safe and long years of use of this machine, perform periodic inspection and maintenance.
Location to Inspection Period
Inspection
Daily Weekly Monthly Tri-monthly
Inspection Method
Outlet
○
１．
Check for any mist leaking from the outlet
hole. In case of a leakage, check the condition
of the drain oil.
２．
Check by putting a hand on air outlet port
that air flow volume is not lowered. If you
recognized air flow volume is decreased,
try to clean the collection disk. (Refer to
the page 24)
Hood, joints, ducts
/ hoses
○
１．
Check for any improper installation state. If
any, correct and reinstall.
２．
Check for any damaged or deformed part. If
any, replace.
３．
Check for any accumulation of mist in the
interior of ducts, hoses or hood. If any, clean.
If any sag is detected, rearrange the lines.
Check on drain oil
○
１．
Check the drain oil hose for any improper
installation. If any, correct and reinstall.
２．
Check for the drainage from the drain oil
hose. If it is poor, clean the interior.
Cyclone
○
１．
Through the inspection port, remove the
contamination that has accumulated inside
the cyclone.
Power cord
○
１．
Check the power cord for any deterioration,
damage, or improper/defective connection. If
exposure of core conductors or worn out
covering is detected, replace with new one.
Terminal mount
○
１．
Check for loosening of the screws of the
terminal mount. If loosened, retighten them.
Voltage of power
supply
１．
Check that the rated voltage is input between
U and V, V and W, U and W). Check troubles
in the power supply for bad voltage or
missing.
Collection disk
Maintenance check is necessary every 2 or 3 years. Contact one of our branches or sales
offices.
Motor
It is necessary every 2 to 3 years of operation. Contact your local AMANO dealer.
※
Above given intervals should be regarded as “standard”. They may vary depending on the
concentration/type of the mist, or working conditions of the machine.