Amana SDE515DAYW, Техническая информация

Страница: 3 / 8

Component Testing Information
!
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect power to dryer before servicing,
unless testing requires it.
June 2004 16023153 Rev. 0
© 2004 Maytag Services
3
Illustration Component Test Procedure Results
Heating element Measure resistance of element from
terminal to terminal.
10.01
−
9.43
Ω
Motor See “Internal Motor Diagram and
Schematic” section.
See following section “Internal Motor
Diagram and Schematic” for correct
wiring contacts.
Belt Verify belt is not damaged or slipping. Wipe excess oil from cylinder, motor
pulley, and belt, to prevent slippage.
Replace belt if damaged.
Cylinder seal Verify air leakage is not present
around cylinder seal. Replace seal, if indication of leakage.
Cylinder glide Verify glides are not damaged. Replace all glides when replacing any
glides.
Sensor Remove wires from sensor terminals
Terminal to terminal ..........................
Any indication other than 0
Ω
, replace
sensor.
0
Ω