Amana PTAC DS02G-H, Руководство по установке

Страница: 5 / 8

5
Final Assembly
1. Slide top of the thermostat down at a slight angle and
press onto the mounting base plate to snap into place.
2. Provided optional security screw may be used in the
lower center of the thermostat.
Optional Security Screw
Note: It is recommended that the installer do a
functional check on unit after the thermostat is
installed and power is restored.
Basic Operation
The MODE button allows for selection of mode of operation
between Off or Auto-changeover.
The FAN button adjusts fan speeds between low fan, high
fan and automatic fan (where the thermostat determines
the most appropriate speed). The FAN button also allows
for the selection of Fan Only mode from the Off mode if air
circulation is desires without temperature conditioning the
room.
The (+) and (–) buttons allow the temperature setting to be
adjusted.
Binding Operation (for Zigbee network)
To Join the thermostat to a Zigbee network, the Zigbee
network must be in discover mode; entering customer’s
network into discover mode is dependent upon the
Zigbee gateway used. When the Zigbee network is in
discover mode, press and hold the MODE and (+) buttons
simultaneously on the thermostat until the displays shows
“00”. The Dot symbol on LCD display starts blinking which
indicates it’s in discoverable mode. The discoverable
mode will last for 30 seconds. Once Zigbee Network
joining process is successful, the dot in the lower left of the
display stops flashing and goes solid and LCD backlight
will start blinking till Identify time expires. The network short
address for identifying this device on the network may be
determined by entering configuration settings per above
and viewing the two values in the “nA” configuration code
The thermostat may be removed from Zigbee network by
holding the MODE and (-) buttons simultaneously until the
dot in the lower left of the display blinks. The thermostat
goes into discoverable mode again and stops blinking after
30 seconds. The dot should not be displayed if thermostat
left the Zigbee network successful.
Note: Once a thermostat has been bound to Zigbee
network, it must be removed from that network
per the instructions above before binding it to a
new network.
CAUTION
This equipment is authorized for use under the
United States Federal Communication Rules
and Regulations, Code of Federal Regulations
Chapter 47 part 15 and must be installed in
accordance with the instructions provided in
this document. Failure to install or operate
this equipment as instructed in this document
could void the user’s authority to operate
the equipment. This equipment countains no
user serviceable parts. Any modification or
repairs to the internal components or to the
antenna configuration of the equipment without
the antenna configuration of the equipment
without the express written consent of Everex
Communications, Inc., could void the user’s
authority to operate the equipment.
NOTE: To comply with FCC RF exposure
requirements in Section 1.1307, a minimum
separation distance of 20-cm (8 inches) is required
between the equipment and all persons.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will occur
in a particular installation. If this equipment
does cause harmful interference to radio and
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Consult the dealer or an experienced radio/TV
technician for help.