Amana NTW5400T, Техническое образование, Страница: 20 / 64

2-
5. Attach the cold water hose to the top inlet
valve.
6. Screw on coupling by hand until it is
seated on the washer.
7. Using pliers, tighten the couplings with
an additional two-thirds turn.
NOTE:
Do not overtighten or use tape
or sealants on the valve. Damage to the
valves can result.
Check for leaks
Turn on the water faucets and check for leaks.
A small amount of water might enter the wash -
er. You will drain this later.
NOTE:
Replace inlet hoses after 5 years of
use to reduce the risk of hose failure. Record
hose installation or replacement dates for fu -
ture reference.
If you connect only one water hose, you
must cap off the remaining water inlet
port.
Periodically inspect and replace hoses
if bulges, kinks, cuts, wear, or leaks are
found.
SECURE THE DRAIN HOSE
1. Remove the shipping material from the
power cord. Drape the power cord over
the console.
2. Remove any cardboard used to move
washer.
•
•
4. Using pliers, tighten the couplings with
an additional two-thirds turn.
NOTE: Do not overtighten or use tape
or sealants on the valve. Damage to the
valves can result.
Beaded tie strap
3. Wrap the drain hose to the laundry tub
leg, drain standpipe or inlet hoses with
the beaded tie strap. Push fastener into
the nearest hole in the beaded tie strap.
See view A or B.
C B A
If the washer faucets and the drain stand -
pipe are recessed, put the formed end of
the drain hose into the standpipe. Tightly
wrap the tie strap around the water inlet
hoses and the drain hose. See view C.
LEVEL THE WASHER
Properly leveling your washer avoids exces -
sive noise and vibration.
Install the front leveling feet
1. Prop up the front of the washer about 4
˝
(10.2 cm) with a wood block or similar
object. The block needs to support the
weight of the washer.
A.Threaded holes for feet
A
4"
(10.2 cm)