Amana NTC3500FW0, Инструкция по использованию и уходу

Страница: 10 / 26

10
Portable Installation
Instructions
Drain System
The washer must drain into a sink or laundry tub with a
carry-away capacity of 17 gal (64.5 L) per minute (for portable
installations). The top of the tub must be at least 27" (68.6 cm)
above floor and no higher than 48" (121.9 cm) from the bottom
of the washer.
27"
(68.6 cm)
1.
Attach hose bracket
Slot
Post
Place the hose bracket over the post on the back of the
washer and position the the tab so it will insert into the slot.
Push down to lock into place.
Connect Fill-And-Drain Hose
Proper connection of the fill-and-drain hose will protect your
floors from damage due to water leakage.
2.
Insert new flat washer into inlet hose
Coupling Washer
Insert new flat washer (supplied) into the end of the inlet hose.
Firmly seat the washer in the coupling.
3.
Connect fill hose
Attach the fill hose to the cold water (left) inlet valve.
Tighten coupling by hand. Use pliers to make an additional
two-thirds turn.
NOTE: Do not overtighten. Damage to the valves can result.
Hot water (right) inlet valve is capped. Leave this valve capped.
4.
Connect drain hose
1
/
4
"
(6 mm)
To keep the fill-and-drain hose from leaking, it must be
installed according to the following instructions.
IMPORTANT: To ensure proper installation, this procedure
must be followed exactly.
Remove permanent installation drain hose. Wet inside end
of the drain hose with tap water.
IMPORTANT: Do not use any lubricant other than water.
Squeeze ears of double-wire clamp with pliers to open. Place
clamp over the straight end of the drain hose ¼" (6 mm) from
the end. Twist hose back and forth while pushing down onto
drain connector at the bottom of the washer. Continue until
hose contacts the cabinet.