background image

12

SPLIT SYSTEMS

AIR CONDITIONING AND HEAT PUMP homeowner’s Routine Maintenance Recommendations

We strongly recommend a bi-annual maintenance checkup be performed

before the heating and cooling seasons begin by a 

qualified servicer

.

Replace or Clean Filter

IMPORTANT NOTE: Never operate unit without a 

filter installed as dust and lint will build up on 

internal parts resulting in loss of efficiency, 

equipment damage and possible fire. 

An indoor air filter must be used with your comfort system. 

A properly maintained filter will keep the indoor coil of 

your comfort system clean. A dirty coil could cause poor 

operation and/or severe equipment damage.

Your air filter or filters could be located in your furnace, in a 

blower unit, or in “filter grilles” in your ceiling or walls. The 

installer of your air conditioner or heat pump can tell you 

where your filter(s) are, and how to clean or replace them.

Check your filter(s) at least once a month. When they are 

dirty, replace or clean as required. Disposable type filters 

should be replaced. Reusable type filters may be cleaned.

You may want to ask your dealer about high efficiency 

filters. High efficiency filters are available in both electronic 

and non-electronic types. These filters can do a better job 

of catching small airborne particles.

Compressor

The compressor motor is hermetically sealed and does not 

require additional oiling.

Motors

Indoor and outdoor fan motors are permanently lubricated 

and do not require additional oiling.  

Clean Outside Coil (Qualified Servicer Only)

WARNING

HIGH VOLTAGE!

Disconnect ALL power before servicing or 

installing this unit.  Multiple power sources may 

be present.  Failure to do so may cause property 

damage, personal injury or death.

Air must be able to flow through the outdoor unit of your 

comfort system. Do not construct a fence near the unit or 

build a deck or patio over the unit without first discussing 

your plans with your  dealer or other qualified servicer. 

Restricted airflow could lead to poor operation and/or 

severe equipment damage.

Likewise, it is important to keep the outdoor coil clean. 

Dirt, leaves, or debris could also restrict the airflow. If 

cleaning of the outdoor coil becomes necessary, hire 

a qualified servicer. Inexperienced people could easily 

puncture the tubing in the coil. Even a small hole in the 

tubing could eventually cause a large loss of refrigerant. 

Loss of refrigerant can cause poor operation and/or severe 

equipment damage.

Do not use a condensing unit cover to “protect” the outdoor 

unit during the winter, unless you first discuss it with your  

dealer. Any cover used must include “breathable” fabric to 

avoid moisture buildup.

BEFORE CALLING YOUR SERVICER

•   Check the thermostat 

to confirm that it is properly set.

•   Wait 15 minutes. Some devices in the outdoor unit or 

in programmable thermostats will prevent compressor 

operation for awhile, and then reset automatically. 

Also, some power companies will install devices 

which shut off air conditioners for several minutes on 

hot days. If you wait several minutes, the unit may 

begin operation on its own.

CAUTION

To avoid the risk of equipment damage or fire, install the 

same amperage breaker or fuse as you are replacing.  If the 

circuit breaker or fuse should open again within thirty days, 

contact a qualified servicer to correct the problem.

 

If you repeatedly reset the breaker or replace

 

the fuse without having the problem corrected, you run the 

risk of severe equipment damage.

•   Check the electrical panel for tripped circuit breakers  

or failed fuses. Reset the circuit breakers or replace 

fuses as necessary. 

•   Check the disconnect switch near the indoor furnace 

or blower to confirm that it is closed.

•   Check for obstructions on the outdoor unit

. Confirm 

that it has not been covered on the sides or the top. 

Remove any obstruction that can be safely  removed. 

If  the unit is covered with dirt or debris, call a qualified 

servicer to clean it.

•   Check for blockage of the indoor air inlets and outlets. 

Confirm that they are open and have not been 

blocked by objects (rugs, curtains or furniture). 

•  

Check the filter

. If it is dirty, clean or replace it.

•   Listen for any unusual noise(s), other than normal 

operating noise, that might be coming from the 

outdoor unit. If you hear unusual noise(s) coming from 

the unit, call a qualified servicer.

Содержание ASXH3 Series

















Отзывы: