Component Testing Information
!
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect power to oven before servicing, unless
testing requires it.
September 1999
RT2310011 Rev. 0
3
Illustration
Component
Test Procedure
Results
31829601
GROUND
MANUAL
REIG
COMMON
NEUTRAL
LIVE
Burner
ignitors
Oven
ignitor
4 + 1 Spark Module
Spark module 4 + 1
Test for voltage at terminals L and N
with switch on.
Verify polarity and ground.
120 VAC
See wiring diagram
31829301
Oven burner spark
ignitor
Disconnect ignitor lead from spark
module.
Attach meter leads to tip of ignitor and
spade receptacle.
Measure for continuity.
Continuity
Infinite
Ignitor good
Replace Ignitor
31827801
Bake burner
Verify gas is supplied.
Orifice adjusted for Natural or LP.
Check for obstructions or
contamination in ports.
31830101
Pilot assembly
Verify pilot selector cartridge is set to
the proper gas (LP or Natural).
Set thermostat to higher than actual
temperature.
Constant pilot flame.
Heater pilot flame envelopes temperature
responsive element.
31715201
LH
0317068
RH
Opening
Oven door hinge
Carefully open the hinge fully, and
insert a wooden dowel or screwdriver
bit into opening.
Remove top and bottom screws
securing hinge.
Slide hinge top towards rear of unit
and guide hinge out through frame
opening or storage drawer.
CAUTION
!
Do not place hands in hinge area when
oven door is removed. Hinge can snap
closed and pinch hands or fingers.
31828101
RH
31828102
LH
Broiler door hinge
Replace hinge if hinge does not
operate properly.
31878002
Clock timer
Verify voltage is present at the input
terminals.
If no voltage is present. Check wiring.
If voltage is present. Replace clock/timer.