Amana AMH20, Руководство по обслуживанию

Страница: 28 / 53

Disassembly
To avoid the risk of electrical shock, personal injury, or death, disconnect power to oven and discharge capacitors
before following any disassembly procedure.
!
WARNING
28 16023463
©2006 Maytag Services
Access
Panel
Insulation
Pad
Figure 6
NOTE: When reassembling unit verify insulation is
properly placed around the element(s), before
securing access panel.
Inlet Duct Assembly
1. Remove back panel, figure 3, page 33, and see “Back
Panel” procedure.
2. Disconnect and label wire terminals from convection
fan motor.
3. Disconnect connector plug, remove from inlet duct.
4. Slide inlet duct assembly away from unit to remove.
5. Reverse procedure to reassemble.
Halfwave Board (60 Hz Models Only)
1. See figure 3, page 33 for location.
2. Disconnect wire terminals from halfwave board.
3. Release mounting clips securing board and remove
board.
4. Reverse procedure to reassemble.
RTD (Resistance Thermal Device)
1. See “Component Location” Figure 3, page 53.
2. Remove outer case, see “Outer Case” procedure.
3. Disconnect RTD harness connector.
4. Remove mounting screws securing RTD to plenum
box, located inside oven.
5. Remove RTD by lifting from top of the oven.
6. Reverse procedure to reassemble.
Top Touch Panel Assembly
1. See “Component Location” Figure 1, page 32.
2. Remove outer case, see “Outer Case” procedure.
3. Disconnect all wire connectors and ribbon cables from
display board.
4. Remove screws securing top touch panel to unit.
5. Remove screws securing display board to top touch
panel assembly.
6. Reverse procedure to reassemble.
Side Touch Panel Assembly
1. See “Component Location” Figure 1, page 32.
2. Remove outer case, see “Outer Case” procedure.
3. Remove ribbon cable from display board.
4. Remove mounting screws securing side touch panel
to unit.
5. Reverse procedure to reassemble.
Display Module
1. See “Component Location” Figure 1.
2. Remove top touch panel, see “Top Touch Panel
Assembly” procedure.
3. Remove screws securing display module to top touch
panel.
4. Reverse procedure to reassemble.
Heating Elements (oven top)
1. Remove outer case, see “Outer Case” procedure.
2. Remove Plenum Plate. See “Component Location”
Figure 2, page 32.
3. Remove screws securing top of heating element
clamp, located inside the oven cavity.
4. Remove screw securing access plate (see figure 6) to
insulation retainer.
5. Remove access plate (figure 2, page 32) and
insulation from unit to gain access to calrod block.
6. Disconnect wire terminals from calrod at terminals.
7. Loosen set screw enough to separate calrod block
from around heating element.
8. Slowly maneuver heating element from inside the oven
cavity to remove.
9. Reverse procedure to reassemble.