•
PIN 1 mode - this method allows a PIN to be set with access via PIN entry.
•
PIN 2 mode - this method also requires a PIN and would generally be use to allow a higher access
level than the first PIN.
•
Super Cal mode - this method requires a power up procedure and will allow access to all functions.
These modes are explained in more detail below.
•
Easy mode - Allows access to the level set by the
EASY LEUL
function in the
ACCS
menu. By
default the Easy access is set to
NONE
level i.e. no access.
The Easy mode simply requires that the
F
button is held pressed until the message
FUNC
is seen
followed by the first function message, this should take approximately 3 seconds. If the message
FUNC End
or no response is seen at this point it means that the access level has been set to
NONE
.
The default access for this level is
NONE
so the access level will need to be changed if access via
this method is required.
•
Remote input mode - Allows access to the level set by the
R.INP LEUL
function in the
ACCS
menu. By default the Remote input access is set to
CAL
level allowing access to all setup functions.
The remote input mode uses the same access method as the Easy mode but also requires that one of
the available remote inputs is set to
ACCS
and that the selected remote input is activated i.e. shorted
to GND. The default access for this level is
NONE
so the access level will need to be changed if
access via this method is required.
•
PIN 1 mode - Allows access to the level set by the
USr.1 LEUL
function in the
ACCS
menu.
The PIN 1 mode requires the
F
button is pressed and released then within 2 seconds press the
^
and
v
buttons at the same time. The PIN can be set via the
Pin.1 CodE
function in the
ACCS
menu. A
USr.1 LEUL
setting of
0
disables the PIN which means that there is no need to enter
the PIN. If the
USr.1 LEUL
function has been set to a number other than
NONE
then the first
function seen when entering via PIN 1 mode will be the function
CodE
. When this function is
seen the PIN value set at the
USr.1 LEUL
function must be entered via the
^
or
v
pushbuttons
followed by pressing
F
to accept the PIN before the user can progress to the setup functions.
4 of
LD5TMRMAN-1.1-0