6
Operating Instructions
To operate the dishwasher:
●
Make sure the inlet and drain hoses are correctly and securely connected.
●
Press the door release button to open the door.
●
Check to make sure that the filter is in the right position.
●
Place the dishes on the dish rack and cutlery inside the cutlery basket.
●
Check to make sure that the rotating spray arm can turn freely all the way round. If necessary remove
any obstacles.
●
Fill the detergent in the recessed area on inner door panel . 12 grams could be added approximately
for a normal cycle. For pre-wash cycle you should not add detergent.
●
Close the door until you hear a ‘click’ sound.
●
Open the water supply.
●
Press the power (on/off) button.
●
Press the button in then power light will light on.
●
Select the desired program by press the program button. The program indicator light will light on.
P1= Intensive Wash
P2=Normal wash
P3=Rapid Wash
P4=3 in 1 Wash
P5=Rinse
●
The appliance will run about 3 seconds later and the program light will flash during all the cycle.
●
At the end of the cycle the dishwasher will stop, the program light will stop flashing and the dishwasher
will beep for several seconds ,Then the light will go out .The power light will not be off until the power
(on/off) button is switched off.
The dishwasher is designed to stop if the door is opened accidentally during washing.
●
You may select another program during operation by pressing the Prog./Start/Reset button over 3
seconds to Cancel the program, then pressing the program button to the desired program.
●
After washing, dishes should be allowed to cool down for about 15 minutes so that they are not too hot
to handle. Dishes will cool quicker if the door is opened slightly.
●
After unloading the dishwasher, remove the filter, clean off any bits of food, and put the filter back in its
position.
！
IMPORTANT
●
Please do not open the door when dishwasher is running. The door could be allowed to open after
pressing the pause button.
●
At the beginning of each cycle, the dishwasher always starts in the “drain” mode. This is because the
drain pump always retains a small amount of water (in the sump) from the previous cycle. This is
necessary to keep the pump primed. Therefore, do not be alarmed if you see a small amount of water
being pumped-out from the drain hose prior to the start of the regular wash cycle .
This is normal.
Cleaning your dishwasher and filter
●
After each wash cycle unload the dishwasher, remove the filter, clean off any bits of food, by placing
the filter under a running cold water tape please ensure that the filter is replaced back into the correct
position before you next wash.