3
Installation Instructions
！
WARNING
A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher.
If your sink has one, it is recommended that the hose be disconnected and the hole plugged.
Remove All Packaging Materials Carefully.
If your existing faucet adapter is not compatible with the hose assembly supplied;
●
Connect the Inlet hose to your faucet.
●
The minimum height clearance required to install your dishwasher on a countertop surface with over-
head cupboards is 45cm
●
Make sure there is an electrical supply (outlet) within reach of the electrical power supply cord .
●
The dishwasher must be installed on a ‘solid’ level surface.
●
To level the dishwasher, adjust the 4 level screws (feet) under the dishwasher.
Water Pressure
For best operating results, incoming water pressure should be between 0.03
～
1Mpa. It is important to
keep the water supply, the inlet hose should be pressurized during the washing cycle.
For the best results
Your dishwasher cleans by spraying a mixture of hot clean water and detergent (under pressure) against
the soiled surface of dishes. The water is pumped through a rotating spray arm, drained through a filter
removing food and soiled particles and pumped back through the spray arm.
Soiled water is pumped out and replaced with clean water at the end of each cycle (the number of times
depends on the cycle being used). For best cleaning results, the water temperature must be at least 45-
55
o
C. To prevent dishwasher damage, the temperature of the incoming water supply should not exceed
60
o
C.
Connecting your Dishwasher
The faucet adapter is compatible with faucets inclusive of either male (outside) or female (inside)
threaded faucet connections.
●
Screw the faucet adapter onto (or into) the faucet tap . Check for leaks (use Teflon tape to eliminate
if necessary).
●
Connect the connection of the drain hose to the drain port connection on the back of the dishwasher
Cabinet .Do not over-tighten (to avoid damage to threads).
●
Connect the star-shaped connection of the inlet hose to the inlet port on the back of the dishwasher
cabinet .Do not over-tighten (to avoid damage to threads).
●
Connect the circular connection of the drain hose into the waste pipe .
●
Connect the circular connection of the inlet hose onto the connection on the quick connect.
●
Slowly open the water line and check for any sign of water leaks at all hose connections. If leaks are
located, immediately close the water supply and repair the hose connections.
Inlet hose and Drain hose Back view Water connection
Drain Hose
Connector
Inlet valve
Power cord
Disconnecting your Dishwasher
●
Close the water supply at the faucet.
●
Disconnect the power supply cord.
●
Disconnect the quick-connect hose assembly by pulling down on the outer locking collar, (thus
releasing the quick-connect from the faucet adapter).