Amaircare® ET Annual Filter Kit Super Standard Installation Instructions for Models 2500 and 3000 (2016) NA
2. Remove the plastic packaging from the new Inner Carbon
Blanket.
3. In the opposite direction to which it was rolled in the package,
roll the new Carbon Inner Blanket into a cylinder.
4. Slide the rolled filter into the center of the HEPA Cartridge and
lightly press the Carbon Inner Blanket into place against the
inside of the HEPA Cartridge.
5. Remove the old O-Ring/Gasket from the Venturi inside the unit.
Replace with the new O-Ring provided in the Annual Kit.
6. Slide the HEPA Cartridge with new Carbon Inner Blanket back in
the center of the unit.
7. Gently press down on the HEPA Cartridge and turn clockwise
until it locks into place.
Close the cabinet
1. Position the hexagonal lid on the unit with the centered hole at
the rear of the unit.
2. To replace the lid screws, press down firmly on the lid to align
the holes and then insert and fasten screws.
3. Plug the unit in and turn it on.
4. To set the Filter Monitors, press and hold the corresponding
buttons on the control pad until the blue LEDs illuminate.
Need help? Call us!
1-800-268-7732
www.amaircare.com
Made in Canada
Americair Corporation
770 Gana Court, Mississauga, Ontario, Canada
Amaircare is a registered trade mark of Americair Corporation in the
United States and Canada.
PREFILTER
HEPA FILTER
VOC BLANKET
VOC CANISTER
PREFILTER
HEPA FILTER
VOC BLANKET
VOC CANISTER
PREFILTER
HEPA FILTER
VOC BLANKET
VOC CANISTER
PREFILTER
HEPA FILTER
VOC BLANKET
VOC CANISTER
PREFILTER
HEPA FILTER
VOC BLANKET
VOC CANISTER
