AMT5500 User Manual
39
7. On the
Host Lease Time
field, if Operation Mode field is DHCP you can modify lease
time. It specify in seconds when an assigned IP address will expire. Once it reaches
this time limit, the DHCP server will then assign a new IP address.
8. Click
Apply
.
9. If you want to check the Internet Protocol Settings values, click
Refresh
button.
4.3.2. MAC address filter
MAC filter provides control over packets transmitted to a specified MAC address on your
wireless network.
To set up MAC address filter:
1. Go to
SETTING > LAN Settings
>
MAC address filter
.
2. On the MAC address filter field, select whether to perform MAC address filter.
Activate:
Allow MAC address filter.
Deactivate (default):
Do not allow MAC address filter.
3. On the MAC address filter mode field, if MAC address filter field is Activate you can
select filter mode.
Allow:
Allow devices in the MAC filter list to access to the wireless network.
Deny (default):
Prevent devices in the MAC filter list to access to the wireless
network.
4. Click
Apply
.
5. If you want to check the MAC address filter lists, click
Get
button.
6. If you want to add MAC address filter, click
Add
button.
7. If you want to modify one of the list of MAC address filter, click
button.
After clicking Apply, the router restarts.
IP only supports IPv4 addresses.
The default value of Start IP Address is 192.168.225.20.
The default value of End IP Address is 192.168.225.60.
The default value of Host IP Address is 192.168.225.1.
The default value of Host Subnet Mask is 255.255.255.0.
The default value of Host Lease Time is 43200 seconds.
If the Start IP Address, End IP Address, and Host IP Address are not within the
range of the Host Subnet Mask, the router may not operate normally.
