ALZRC DEVIL 380 FAST, Инструкция по эксплуатации, Страница: 37 / 38

36
机头罩固定垫圈
Canopy Lock Washer
Chapter 59
D380F - H - 3
第 58 步组装完成
Assembled in Chapter 58
机头罩固定垫圈
Canopy Lock Washer
机头罩固定垫圈
Canopy Lock Washer
机头罩快拆固定柱- B
Canopy Release Mounting
Bolt B
机头罩快拆固定柱- B
Canopy Release Mounting Bolt B
正确的安装方法。
The correct installation method.
飞行前的操作
OPERATIONS BEFORE FLIGHT
● 再次检查所有设备是否设置正确 。
● 检查主旋翼和尾旋翼是否安装正确。
● 检查全部螺丝、螺帽是否拧紧及安装正确。
● 对于
3D 飞行，设置约 + / - 12.5 ° 。
● 第一次飞行，建议用 2500 ~ 2600 转低转速下进行。
* Recheck whether the setup for all equipment has been set up correctly.
* Check whether the main blade and tail blade is installed correctly.
* Check whether all the screws, nuts are tighten and installed correctly.
* For 3D flight, set about +/- 12.5°.
* Perform the first flight at a low head speed, 2500/2600 RPM.
● 2-3 个起落以后，检查所有的螺丝、螺帽、皮带、球头扣等配件是否正常。
● 如飞行时直升机发出异响，为保证飞行安全，请逐一排查，多数为皮带不
够紧绷的原因所造成。
* It's very important to check the model thoroughly after the first 2-3
flights. Check all bolts, screws, belts, ball links, etc.
* If the model is making strange noises, this can be usually attributed to
incorrect belt tensions. Check the belts again and tighten if necessary.
组装说明 ASSEMBLY SECTION