MS-MATRIX – User’s manual © - Revision 1.8
Page 11
5.6 Settings
5.6.1
Assigning a MIDI Note to Preset 01
By default Preset 01 corresponds to key C3 (MIDI Note 48). Consecutive chromatic notes
correspond to the rest of the Preset locations as shown below.
If your keyboard range is too short, the lowest key which will correspond to Preset 01 can
be reassigned:
1. Make sure you have your MIDI keyboard properly connected to the MIDI IN input of
the MS-MATRIX
2. Turn the Eurorack case power off.
3. Push and hold the push button while turning the Eurorack case power back on.
4.
NEW NOTE
is displayed on the LED display
5. Release the Mode push button (Mode button)
6. Press the desired key on your MIDI keyboard (Note On), hold it for at least 5 seconds
or wait for the MIDI/CV LED to flash 4 times and then release the key (Note Off).
7. The MIDI/CV Mode LED flashes 4 times and the new lowest Note is saved.
8. The initialization sequence is begins (see paragraph 5.1)
There is no need to repeat this operation every time you turn the module on, since the
lowest Note is stored in the non-volatile memory of the module.
In step 6, if more than one keys are simoultaneously pressed for more than 5 seconds,
only the one pressed earlier will be used for setting the new lowest key for Preset 01.
5.6.2
Setting Auto Save or Manual Save
To change the method Presets are saved:
1. Turn the Eurorack case power off.
2. Push and hold the INPUT/SAVE encoder while
turning the Eurorack case power back on.
3. Release the encoder.
4. Turn the OUTPUT/LOAD encoder to choose
between
AUTO SAVE
and
MAN. SAVE
as indicated on the LED display.
5. Push the OUTPUT/LOAD encoder to confirm your selection.
6. The Initialization sequence begins (see paragraph 5.1)
