TARGO DRIVES (TR SERIES)
|
ANTRIEBE TARGO (SERIE TR)
|
COMMANDES TARGO (SÉRIE TR)
13
TROUBLESHOOTING
9.
TROUBLESHOOTING
FAULT
POSSIBLE REASON
RECOMMENDATIONS
Drive does not work
No supply voltage, poorly clamped
wires on terminals
Check the supply voltage. Clamp wires
on terminals
Drive does not work
The drive is unlocked or the emergency
manual control chain is activated
Lock the drive. Check the operation of
the emergency manual control chain
The door moves in the wrong
direction
The correct direction of the doors
movement has not been checked
Make the correct adjustment of the
control unit
The door stops, but the drive
continues to operate
An obstruction is in the path of door
movement, wrong drive adjustment
Eliminate the obstruction in the path
of door movement, check adjustments
of the final positions
The door does not stop at the
required final positions
The final positions are not adjusted or
have changed
Adjust the final positions
The drive suddenly stops
during the door movement
Thermal protection of the drive motor
has tripped
Allow the drive motor to cool down
Y
In the case of a failure, which cannot be repaired using the information provided in this
manual, consult the service department. Information about the service department can be
obtained from your supplier (vendor, installation company).
10. STORAGE, TRANSPORTATION AND DISPOSAL
The product shall be stored in its packaging in closed dry spaces. Do not expose to atmospheric
precipitation or direct sunlight. Shelf-life is 3 years from the manufacture date. Transportation
can be performed using all types of covered ground vehicles, fitted with measures to prevent
shock and movement inside the vehicle.
Disposal of the product shall comply with the regulatory and legal requirements on
recycling and disposal, valid in the user’s country. The product does not contain
substances, posing danger to life and health of people, and the environment.
11. WARRANTY OBLIGATIONS
• The operational capacity of the product is guaranteed only when the rules governing
its storage, transportation, adjustment, operation are followed; when mounting and
maintenance (timely and due) is performed by an organisation, specialising in the sphere of
automation and authorised to perform mounting and maintenance operations.
• The warranty period is __________________ and starts from the date of product delivery to
the Customer or from the production date, when the delivery date is not known.
• During the warranty period any defects, caused by the Manufacturer, are repaired by the
service department, providing warranty maintenance.
Note
: the parts, replaced by the service department, performing the product repair, become
the department’s property.
• Warranty is not applied in the following cases:
− violation of storage, transportation, operation and mounting rules;
− mounting, adjustment, repair, re-mounting or modification of the product by persons,
not authorised to perform such works;
Table 3
