Alutech A-box/ADS, Инструкция по установке и эксплуатации

Страница: 15 / 26

Installation and operation Manual
|
Switching Set A-box / ADS
13
ELECTrICAL InTErFACES
Fig. 2 – Cable entry in the terminal block
4. ELECTrICAL InTErFACES
Electrical interfaces of protective sensors cables and spiral cable are connected to the switching
module sockets ( Figure 3).
Fig. 3 – Switching module
•
Sk
– screw socket for spiral cable connection
•
ST – two screw sockets for door wicket sensors
and pull line loosening sensors connection
•
STX – special socket for wicket sensor connection
•
Sk1 / Sk2 – special sockets for optical sensors transmitter and receiver connection
•
oSE
– screw socket for optical sensors connection
•
J1 / 2 – switching jumpers
Prior to connecting check the quantity and type of protective sensors, installed on the door leaf,
determine the wiring diagram!
Y
Prior to wiring operation make sure that the wire is deenergized.
Y
Connection of the wicket sensor, pull lines loosening sensors, optical sensors with the
help of switching assembly A-box / ADS ( Fig. 4).
Y
Attention! remove jumper J1 (4 pol.). The jumper is designated for use of four-core
spiral cable. when connecting five-core spiral cable (included in the assembly) the
jumper is not installed. keep the jumper J1.