- 11 -
3
1. Programming the first transmitter
In an interval of about two
seconds, press the "P2" button
twice and you will hear an
acoustic signal (x2 BIP)
x2 BIP
OK
After correct programming
the motor will make a move
UP and DOWN
x1 BIP
Press the "UP" button and you
will hear an acoustic signal
(x1 BIP)
Press the SET button
(on tubular motor’s head) one
time, 1 short beep will be
heard immediately (1xBIP).
x1 BIP
NOTE
- adjust the maxiumum torque of the motor (Nm) to the weight of the curtain,
- it is recomended to use side locks or stoppers in the endslat,
For a proper operation of the overload system
- it is recomended to use security springs WB or WL&P,
II
After correct programming
the tubular motor will make a move
DOWN and UP and it is ready
to regular using.
Hold the button till the tubular motor will
make a move UP and DOWN. This means that
the directions of the movement have been
changed
Press and hold the SET button
(on tubular motor’s head)
for 6 seconds.
x2 BIP
In an interval of about two
seconds, press the "P2" button
twice and you will hear an
acoustic signal (x2 BIP)
2. Programming the direction of movement
OK
I
OK
x1 BIP
Press the "DOWN" button
and you will hear an acoustic
signal (x1 BIP)
Press the SET button
(on tubular motor’s head)
one time, the motor will make
a move UP and DOWN
- upper and lower limit position sholud be set up.
