Page 8 of 9
G03711103
8-22-06
15
14
13
Cut the drip rail [
R
] to the length of the bottom rail
minus 11/16". Clean the bottom door rail and the drip rail
thoroughly to ensure proper adhesion. Unroll the double stick
tape [
V
] and carefully apply it to the back of the drip rail (do not
peel the tape backing yet).
Insert the tapered drip vinyl [
T
] into the drip rail. Position the
drip rail flush with the bottom and pivot side of the door panel
[
L
], then raise the strike side until the bottom edge of the drip
vinyl is parallel to the curb [
A
]. Mark the location of each end
of the drip rail.
Insert the two nylon pivot bushings [
Y
] into the
pivot holes in the head and curb fillers [
P
].
Lift the door panel [
L
] and insert the top pivot pin into the
pivot bushing in the header filler. Hold the door vertical
and insert the bottom pivot pin into the pivot bushing in
the curb filler. It may be necessary to remove the header
retaining screws and raise the header slightly to install the
door.
When the door has been set into place, snap the security
washer [
AA
] over the top pivot pin to hold the upper pivot
bushing in place and prevent accidental dislodging of the
door.
Adjust the drip vinyl [
T
] by sliding it left or right
until it just touches the curb. Trim the vinyl (flush with
the pivot end and notch 1/4" longer than the drip rail as
shown on the strike end).
The drip plug [
S
] is supplied with a left and right hand
plug together. Break the right and left drip plug apart and
insert the appropriate plug into the high (strike) side of
the drip rail. Discard the unused drip plug. Peel off the
tape backing and carefully press the drip rail [
R
] to the door in
the marked position.
