Page 4 of 9
G03711103
8-22-06
1
The
A
LUMAX
794
S
S
PEED
S
TALL
Shower Enclosure
is completely reversible and may be installed pivot-left or
pivot-right. For maximum waterproofing, the pivot jamb
should be opposite the shower head. Using the diagram,
determine the correct position for the door in your
particular S
PEED
S
TALL
installation. This instruction sheet
depicts a pivot-right installation.
CAUTION
: For safety reasons, the door panel must
always open
outward
.
NOTE: If the curb and header sections come pre-
assembled, skip to Step
#3
.
Assemble the curb sections [
A
] (with weep slots) by
sliding a 135° anchor plate [
B
] into the mitered ends and
forcing the sections together. The weep slots in the curb
must be to the inside. Screw four #8 x 1/4" truss head
screws [
C
] through the slots in the anchor plates into the
curbs. As you tighten the screws, be sure the mitered ends
are forced tightly together. To increase the rigidity of the
mitered joint, drill 1/8" holes into the curb through the
round holes in the anchor and install two more #8 x 1/4"
screws.
Assemble the two header sections [
D
] in the same manner
and set the header assembly aside.
2
3
Measure the opening at the bottom of the shower
stall and trim the ends of the curb assembly [
A
] (with
weep slots) to fit the shower sill. The curb should sit near
the centerline of the sill. If required, use a file to round
the lower ends of the curb assembly to fit the shower sill
properly.
Using a 3/16" drill bit, drill the interior face of the curb
assembly on both ends as shown.
Reposition the curb assembly on the shower sill and mark
its position with a pencil line along the interior and
exterior base.
