Power Transformer
Power Converter
USB Connector
4. Pull wire from touchpad
to AC outlet. If replacing an existing touchpad, existing wiring can
be used; however, new touchpad must be powered by supplied 12V DC power transformer.
Do not power from existing panel.
5. Connect wire
to provided power transformer.
NOTE:
Power Converter must be powered by supplied 12V DC Power Transformer. Do not
power from existing panel or other power supply.
6. Splice power converter
wires to wires pulled from AC outlet.
7. Ensure correct
polarity. Red wire must connect to +12V of power transformer.
8. Plug USB connector
into the display.
9. Place power converter
and excess wire inside the wall.
10. Snap the display
into the back plastic (ensure camera is on the left side).
11. Align the front cover
and snap into place.
12. Plug in the Power Transformer
and ensure the display lights up. If display does not light up,
unplug power transformer and verify wire polarity.
See table below for Max Wire Length
WIRE GAUGE
MAXIMUM WIRE LENGTH BETWEEN POWER
TRANSFORMER AND TOUCHPAD
#24
Up to 50 feet
#22
Up to 75 feet
#20
Up to 125 feet
#18
Up to 200 feet
#16
Up to 300 feet
Power Converter
Splice
Power Transformer
Display
